Milwaukee 14-30-0082 Gear Case Assembly

**Milwaukee parts change not only by model# but also by serial number. Milwaukee’s site lets youlook up your tool’s parts diagram.Milwaukee Gear Case AssemblyModel Number: 14-30-0082The Milwaukee 14-30-0082 is a genuine OEM Gear Case Assembly for use in compatible Milwaukee tools. The gearcase assembly is the precision housing that encloses and supports the tool’s complete gear reduction system containing the intermediate shafts, bearing supports, gear clusters, and lubricant that transmit motor torque to the output spindle at the correct speed and torque ratio. The gearcase provides the structural connection between the motor housing and the tool’s output, bearing the reaction forces generated during operation. A cracked, stripped, or damaged gearcase that allows gear misalignment, lubricant loss, or bearing failure requires replacement to restore proper drivetrain function and safe tool operation.Using a genuine Milwaukee OEM gearcase assembly ensures the correct bearing bore dimensions, gear mesh clearances, and structural integrity for the drivetrain it houses. Non-OEM gearcase assemblies may not maintain the precise bearing alignment required for quiet, efficient gear operation. Always verify your catalog number and serial number on Milwaukee’s website before ordering to confirm this is the correct gearcase assembly for your specific unit.FeaturesGenuine Milwaukee OEM gear case assembly for compatible Milwaukee toolsEncloses the complete gear reduction system including shafts, gears, bearings, and lubricantProvides structural connection between motor housing and output spindlePrecision cast to maintain correct gear mesh clearances and bearing bore alignmentVerify catalog number and serial number on Milwaukee’s website before orderingSpecificationsType: Gear Case AssemblyMaterial: Die Cast AluminumApplication: Gear Reduction System Enclosure and Structural SupportCompatibility: Always verify using your tool’s parts breakdown diagram at milwaukeetool.comIncludes(1) Milwaukee 14-30-0082 Gear Case AssemblyPlease note: several of the screw holes in this gear case assembly are unthreaded by design. They are intended for self-tapping (thread-forming) screws that cut their own threads as they are driven in, so these holes arrive without pre-cut threads. Unthreaded holes on this assembly are normal and are NOT a defect or a manufacturing error. Use the correct self-tapping screws shown in the tool’s parts diagram and drive them into the original hole locations so the threads form correctly.