Milwaukee 49-80-0400 M12 Soldering Iron Pointed Tip

**Milwaukee parts change not only by model# but also by serial number. Milwaukee’s site lets youlook up your tool’s parts diagram.Milwaukee M12 Soldering Iron Pointed TipModel Number: 49-80-0400The Milwaukee 49-80-0400 is a genuine OEM Pointed Tip replacement for the Milwaukee M12 Cordless Soldering Iron a precision-machined soldering tip with a pointed profile for fine-pitch and precision soldering work where the smallest possible heat application area is needed for accurate soldering in tight component spaces. The pointed tip is the finest standard soldering tip geometry in the Milwaukee M12 soldering iron lineup the sharp tip contacts the solder joint at a single point of minimum contact area, allowing precise heat delivery to very small solder pads, fine-pitch SMD component leads, and the precision through-hole component pin work in control panel assemblies and instrumentation work where larger tip profiles would inadvertently heat adjacent components and conductors. The pointed tip is the appropriate choice for low-voltage electronics, small sensor connections, and the precision electrical work that requires the finest possible heat control and targeting accuracy.The pointed tip replaces the original tip when it oxidizes beyond reconditioning, develops erosion from normal soldering use that widens the tip beyond the precision point profile, or is physically damaged. Using a genuine Milwaukee OEM replacement tip ensures the correct tip material composition, plating, and thread specification for the M12 soldering iron’s tip retention mechanism and temperature calibration after-market tips with different material composition produce different actual tip temperatures at the same iron setting, compromising the temperature management that precision soldering requires. Always verify compatibility with your specific Milwaukee M12 soldering iron model before ordering replacement tips.FeaturesGenuine Milwaukee OEM pointed tip for Milwaukee M12 Cordless Soldering IronFinest precision geometry for fine-pitch SMD, sensor, and control panel solderingMinimum contact area for precise heat targeting without heating adjacent componentsReplace when tip oxidizes beyond reconditioning or develops erosionOEM material and plating ensure correct temperature at M12 iron calibration settingsSpecificationsTip Profile: PointedCompatible Tool: Milwaukee M12 Cordless Soldering IronApplication: Fine-Pitch Electronics, SMD Components, Precision Control WiringIncludes(1) Milwaukee 49-80-0400 M12 Soldering Iron Pointed Tip